Home / Job Cover Letters / Leadman Turbine Assembly Job Cover Letter

Leadman Turbine Assembly Job Cover Letter

Leadman Turbine Assembly Job Cover Letter Template
This sample leadman turbine assembly job cover letter shows details such as sender and receiver information, using of work experience, and how to express your interest to the hiring manager.
See also: How Do You Write a Cover Letter
Example for Leadman Turbine Assembly
From / Sender

- Applicant full name
- Applicant Address
- Applicant contact no.
- Applicant email address
To / Receiver

- Employer title/Name
- Employer position
- Organization name
- Organization address

Dear Hiring Manager:

This is to express my interest in "leadman turbine assembly" position advertised on June 13, 2014; My resume is enclosed for your review. Given my closely experience and excellent capabilities I would appreciate your consideration for this job. My work experience and duties are an ideal match for this position and cover all job requirements.

Your Requirements:

Expert Leadman Turbine Assembly with at least 2 years of experience, excellent covers all position duties.

My Matching Experience:

For 3 years I worked as Leadman Turbine Assembly, My Responsibilities were to:

1) Fits and assembles machined parts and castings to erect steam and gas turbines according to drawings specifications, using machine tools, power tools, handtools, and measuring instruments

2) Erect, levels and aligns vertical supports for bedplates of steam turbines, using levels, transit and master straightedge

3) Lays out work for other assemblers on thrust end, oil tank and cylinder assemblies, following specified assembly procedure

4) Chip, grinds, bores, and drills machined parts castings, using portable grinders, boring bar, and lapping disk

5) Level and aligns high low pressure cylinders, oil tank, thrust end assembly, and exhaust assembly, using pin gauges

6) Scribe foundation holes, lays out offset marks, and directs machine operator to drill foundation holes

7) Shrink-fits spindle blade rings, diaphragm rings, dummy rings, ring gears, sleeves, couplings, and bushings on shafts to build turbine spindles, using portable gas heating unit

8) Measure clearance and alignment of spindle to cylinder, using micrometers calipers

9) Adjust spindle bearing pads or moves blade rings to obtain specified clearances

10) Start auxiliary oil pump to flush oil piping bearings

11) Start turbine measures balance of spindle, using vibroscope

12) Observe functioning of unit and instruments to adjust alignment and clearances to assure operation according to specifications

13) Repair worn damaged turbines.

I appreciate your time taken to review my credentials and experience.

I look forward to being interviewed at your earliest convenience. Lot of thanks for your consideration and care.

[ Sender/your name ]

Enc: Resume

More Job Cover Letters For:
Share on Facebook Share on Twitter Share on LinkedIn

Home | About Us | Contact | Privacy Policy | Terms of Use

Copyright 2011 - 2019 - All Rights Reserved