Job Descriptions And Duties
Home » Experience Letters » Flame Spray Operator Experience Letter

Flame Spray Operator Experience Letter

Flame Spray Operator Experience Letter Template
Searching for flame spray operator experience letter sample, this template example - ref.#6493 - provides a career reference guide to help you create and write a work expeience certificate letter for flame spray operator using a simple format.

Flame Spray Operator Work Experience Letter

To Whom It May Concern

This is to certify that ...(employee title) ... (employee name) was working at ...(organization name) As Flame Spray Operator from ... (joining date) to ...(last working date).

During this period, his services were found to be satisfactory in carrying out the job duties, his responsibilities were to:

1) Sets up and operates flame-spray equipment machine tools to build up worn parts, like crankshafts, motor shafts, clutch plates, and piston rods, and to salvage defective machined parts, according to specifications

2) Wash object with solvents, or heats object with torch or in furnace to remove impurities, like grease or paint

3) Operate machines, like engine lathes external grinders, to undercut or groove surface of object

4) Clean roughens surface of object in sand or shotblast cabinet [Cabinet-Abrasive Sandblaster any industry 503.687-010] or by electrobonding process

5) Preheat object for spraying, using oxyacetylene torch or metalizing gun

6) Spray metal or other material on object by either of following methods

7) 1 Positions clamps metalizing gun to engine lathe carriage

8) Select nozzle to accommodate size of wire to be sprayed screws nozzle into place on metalizing gun

9) Insert wire to be sprayed into rear of gun and through feed rollers nozzle

10) Connect hoses from gun to air compressor and tanks of oxygen fuel gas, like acetylene

11) Turn knobs to synchronize speed of wire feed, air pressure, flow of oxygen fuel indicated on dials to specifications computed from data charts

12) Install gears in lathe and turns knobs to synchronize rotating speed of chuck movement of carriage with rate of spray to achieve specified coating on workpiece

13) Ignite gases to melt wire and presses button or trigger to release compressed air which atomizes sprays molten metal onto workpiece

14) 2 Pours specified powder of metal or other material, like ceramics, into hopper mounted on metalizing gun

15) Select nozzle according to type of powder to be used screws nozzle into place on gun

16) Turn dials and valves to synchronize feeding rate of powder and flow of oxygen fuel gas, according to type of powder used

17) Ignite gases and presses button or trigger to start flow of powder which is atomized sprayed onto workpiece

18) Heat object with torch or in heat-treating furnace to fuse coatings, and cools object slowly to prevent cracking

19) Measure object, using measuring instruments, like micrometers, gauges, and calipers, to define conformance to specifications

20) Operate portable metalizing gun to fill cracks, holes, and apply coating to restore flat or irregular surfaces of machined, forged, or cast objects to original dimensions

21) May operate machines, like engine lathes, turret lathes, or precision grinders, to machine-coat objects to original specifications

22) May spray protective coatings of corrosion-resistant metal onto metal objects

23) May tend portable air compressors, sandblasting guns, and set up metalizing gun on lathes in customers plants to repair damaged, worn, or improperly machined parts

24) May be designated according to type of metalizing equipment used as Thermospray Operator any industry .

We wish him/her all the best in his future
For ...

...(organization stamp)

Continue With "Flame Spray Operator" »
Back to Top