Job Descriptions And Duties
Home » Cover Letters »

Etched Circuit Processor Cover Letter

Search Cover Letters
Etched Circuit Processor Cover Letter Template
Searching for etched circuit processor cover letter sample, this template example - #11008 - will help to write a cover letter for etched circuit processor.
For related free downloads click here.
Example Helps With Cover Letter Writing

Dear Ms. Smith,

This is to express my interest in etched circuit processor position advertised on June 13, 2014; My resume is enclosed for your review. Given my closely experience and excellent capabilities I would appreciate your consideration for this job. My work experience and duties are an ideal match for this position and cover all job requirements.

Your Requirements:
"Expert etched circuit processor with at least 2 years of experience, excellent covers all position duties"

My Matching Experience:
For 3 years I worked as etched circuit processor; My responsibilities were to:

    Perform any combination of following tasks to print etch conductive patterns on copper-faced plastic, fiberglass, or epoxy board to fabricate printed circuit boards Pcbs

    Cuts board to designated size, using sheet metal shears, following written or verbal instructions

    Sand board & either places board in vapor degreaser or immerses board in chemical solution to clean and remove oxides other contaminants

    Spray or brushes light-sensitive enamel on copper surface places board in whirler machine to spread enamel evenly, or tends machine that flows light-sensitive resist over board

    Laminate light-sensitive dry film to board, using heat pressure equipment

    Expose board circuit negative to light in contact printer for specified period of time to transfer image of circuit to board

    Immerse exposed board in solution to develop acid-resistant circuit pattern on surface

    Compare board to sample to verify development of pattern

    Apply acid resist over sections of pattern not developed, using brush

    Immerse board in acid or tends etching machine to etch conductive pattern on copper surface

    Immerse board in solution to dissolve enamel

    Drill holes in board, using drill press, following work sample, drawing, and diagrams

    Install hardware, like brackets, eyelets, and terminals, using eyelet machine hand arbors

    Reduce circuit artwork prior to printing onto board, using reduction camera

    Print conductive pattern onto board, using silk screen printing device

    Fabricate Pcb used as prototype of production model.

I appreciate your time taken to review my credentials and experience.

I look forward to being interviewed at your earliest convenience. Lot of thanks for your consideration and care.

Sincerely,
Flori Rothenberg

Back to Top